CP.Inc has decided to network three (3) locations to improve efficiency in inventory control. The routers have been named to reflect the location: -RA, -RB, -RC. The necessary networking has been completed at each location, and the routers have been configured with single area OSPF as the routing protocol. The -RA router was recently installed but connectivity is not complete because of incomplete routing tables. Identify and correct any problem you see in the configuration.

NOTE: The OSPF process must be configured to allow interfaces in specific subnets to paricipate

in the routing process.

Answer: Login -RA router.

Explanation:
-RA>enable
password: cisco
-RA#config terminal
-RA(config)#router ospf 2
-RA(config-route)#no network 192.168.121.0 0.0.0.4 area 0 -RA(config-route)#network 192.168.121.0 0.0.0.3 area 0 -RA(config-route)#end
-RA#copy run start