In which two directions are the Cisco ASA modular policy framework inspection policies applied? (Choose two.)

Which two statements about Cisco ASA 8.2 NAT configurations are true? (Choose two.)

Refer to the partial Cisco ASA configuration and the network topology shown in the exhibit.

Which two Cisco ASA configuration commands are required so that any hosts on the Internet can HTTP to the WEBSERVER using the 192.168.1.100 IP address?
(Choose two.)

Which three types of class maps can be configured on the Cisco ASA appliance? (Choose three.)

On Cisco ASA Software Version 8.4 and later, which two options show the maximum number of active and standby ports that an EtherChannel can have? (Choose
two.)

Which three actions can be applied to a traffic class within a type inspect policy map? (Choose three.)

Which two options show the required Cisco ASA command(s) to allow this scenario? (Choose two.)
An inside client on the 10.0.0.0/8 network connects to an outside server on the 172.16.0.0/16 network using TCP and the server port of 2001. The inside client
negotiates a client port in the range between UDP ports 5000 to 5500. The outside server then can start sending UDP data to the inside client on the negotiated port
within the specified UDP port range.

Which two Cisco ASA configuration tasks are necessary to allow authenticated BGP sessions to pass through the Cisco ASA appliance? (Choose two.)

On Cisco ASA Software Version 8.4.1 and later, which three EtherChannel modes are supported? (Choose three.)

Which four unicast or multicast routing protocols are supported by the Cisco ASA appliance? (Choose four.)