How would you configure IS-IS process TEST to support MPLS Traffic Engineering extensions on level
1 and 2 that are intending to run a tunnel across TenGigE 0/0/0/0?

How would MPLS Label Distribution Protocol, Graceful Restart be configured on TenGigE 0/0/0/1?

Which three commands can verify that the route-policy shown below and applied inbound on the
BGP neighbor is working as expected for prefix 2.0.0.0/8?
(Choose three.)

Which of the following configurations adds a community to routes that are matched on AS criteria?

Which Cisco IOS XR show command is used to display the IPv4 BGP table?

What is the correct Cisco IOS XR command to configure an autonomous system number 1000 for
BGP and to support IPv4, IPv6, and unicast routing?

What is the correct procedure to associate a VRF to a static route?

Which is-is router interface configuration command will configure the authentication password for
IS-IS Hello (IIH) messages without actually sending the password with the IIH over the network?

Which command should be used to view only the running configuration of OSPF in Cisco IOS XR
Software?

Which Cisco IOS XR only command will show the status of IPv4 interfaces that have been configured
under the OSPF process?