Refer to the exhibit. Which three statements are true about the configuration? (Choose three.)

class-map class-1
match ip rtp 2024 1000

class-map class 2
match dscp 5 6 7

policy-map access-group-1-traffic
class class-1
shape peak 16000
class class-2
police 8000 1000
conform-action set-dscp-transmit 1
exceed-action set-dscp-transmit 0
violate-action drop
class class-default
fair-queue 16
queue-limit 20

interface fastethernet 0/0
service-policy output access-group1-traffic

When LLQ is being configured, which IOS command is used to limit the traffic rate on the priority queue even when the other class queues are not congested?

Based on the Cisco Catalyst 2950 Series switch configuration shown, with no weights being assigned to the egress queues, which type of queuing is being implemented?

wrr-queue cos-map 1 0
wrr-queue cos-map 2 1 2 3
wrr-queue cos-map 3 4 5
wrr-queue cos-map 4 6 7

When configuring WFQ, what is the default number of dynamic queues based on?

Which command is typically applied to the voice traffic class within a policy-map?

Based on the following Cisco Catalyst 2950 Series switch configurations, which additional command will enable these actions?

Traffic marked with a CoS of 6 or 7 will be serviced by the priority queue.
Traffic marked with a CoS of 0, 1, or 2 will have a 20-percent weight when serviced by the wrr queue.
Traffic marked with a CoS of 4 will have a 30-percent weight when serviced by the wrr queue.
Traffic marked with a CoS of 3 or 5 will have a 50-percent weight when serviced by the wrr queue.

Catalyst 2950 partial configuration:

no wrr-queue cos-map
wrr-queue cos-map 1 0 1 2
wrr-queue cos-map 2 4
wrr-queue cos-map 3 3 5
wrr-queue cos-map 4 6 7

To determine the bandwidth requirement for each VoIP call, not including Layer 2 overhead, how much bandwidth per call should be added to account for the voice signaling traffic?

This policy-map is applied to a 128-kbps serial interface in the output direction. Which set of additional commands within this policy-map will improve the link efficiency on the serial interface?

policy-map test
class voice
priority 25
class telnet
bandwidth remaining percent 20
class ftp
bandwidth remaining percent 30

Which three factors will affect processing delay? (Choose three.)

The show policy-map interface command output is showing too many random drops for the mission-critical traffic class. What can be changed to reduce the random drops?