An OSPF LSA type 1 route is redistributed into MP-BGP. That same route is then redistributed back from MP-BGP into OSPF on another PE router. In this case, which LSA type on the destination CE router will the OSPF route appear as?

An OSPF route is redistributed into MP-BGP with the following extended community: Extended Community: RT:1:10 OSPF RT:0:1:0 Which parameter(s) will the OSPF RT:0:1:0 indicate?

The following partial output is a PE router configuration related to the OSPF process. During troubleshooting, you notice that the OSPF routes from the remote sites are not showing up in the local CE router. What is a problem that can cause this issue?router ospf 1 vrf ABC network 0.0.0.0 255.255.255.255 area 0 redistribute bgp 55111

Which two of the following describe the actions that the OSPF routing process on a PE router will take based on the down bit being set? (Choose two.)

What is the purpose of the area {area-id} sham-link {source-address} {destination-address} cost {number} command?

When using MPLS unicast IP forwarding, what will happen if an LSR receives an incoming labeled packet but the LSR can’t find that incoming label in its LFIB?

Which three statements correctly describe how labels are used in cell-mode MPLS? (Choose three.)

Which statement represents the overall impact of convergence in a frame-mode MPLS network when there is a failure on a link that an LSP is using?

Which statement correctly describes managed CE routers service?

What is wrong with the following MP-BGP to EIGRP route redistribution configuration?
router eigrp 100
address-family ipv4 vrf XYZ
autonomous-system 200
redistribute bgp 51001