You are configuring a fiber connection between two Cisco Catalyst 3750 switches on which UDLD is disabled. You connect both the transmit and receive connectors on one end of the cable to port 1/0/9 on SwitchA. However, you accidentally connect the transmit connector from SwitchA to the receive connector on port 1/0/7 on SwitchB and the receive connector from SwitchA to the transmit connector on port 1/0/8 on SwitchB.

Which of the following statements are true? (Choose two.)

You are adding an additional LAP to your current wireless network, which uses LWAPP. The LAP is configured with a static IP address. Which of the following steps is the first step when the LAP attempts to register with a WLC?

Which of the following will generate an RSTP topology change notification? (Select the best answer.) *

Which of the following HSRP router states does an active router enter when it is preempted by a higher priority router? (Select the best answer.)

You administer a network that uses two routers, R1 and R2, configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows:

R1#configure terminal
R1(config)#interface fa0/0
R1(config-if)#ip address 10.10.0.5 255.255.255.0
R1(config-if)#standby 1 priority 150
R1(config-if)#standby preempt delay minimum 50
R1(config-if)#standby 1 track interface fa0/2 15
R1(config-if)#standby 1 ip 10.10.0.20

Which of the following describes the effect the "standby preempt delay minimum 50" command will have on router R1? (Select the best answer.)

Which statement is correct about the use of the virtual interface on a WLC?

What is the effect of configuring the following command on a switch?

Switch(config)# spanning-tree portfast bpdufilter default

Which two statements are true about a switched virtual interface (SVI)? (Choose two.)

Which set of statements about Spanning Tree Protocol default timers is true?

Which statement is correct about 802.1Q trunking?