Which interoperability technique implemented on the dual-stack routers would allow connectivity between IPv6 s
Refer to the exhibit. Which interoperability technique implemented on the dual-stack routers would allow connectivity between IPv6 sites across automatic created tunnels using the 2002::/16 prefix?
Select the best response.
Which router will R1 select as the successor and feasible successor for Network A?
Refer to the exhibit. EIGRP has been configured on all routers in the network. The command metric weights 0 0 1 0 0 has been added to the EIGRP process so that only the delay metric is used in the path calculations.
Which router will R1 select as the successor and feasible successor for Network A?
Select the best response.
Which statement is true about the NSSA Area 1?
Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has been configured as a NSSA. Which statement is true about the NSSA Area 1?
Select the best response.
what two statements must be true?
Refer to the exhibit. On the basis of the output from the show ipv6 interface command, what two statements must be true? (Choose two.)
Select 2 response(s).
What two statements are true?
Refer to the exhibit. What two statements are true? (Choose two.)
Select 2 response(s).
Which statement best describes the reason for the error messages?
Refer to the exhibit. EIGRP had converged in AS 1 when the link between router R1 and R2 went down. The console on router R2 generated the following messages:
*Mar 20 12:12:06: %DUAL-5-NBRCHANGE: IP-EIGRP 1: Neighbor 10.1.4.3 (Serial0) is down:
stuck in active
*Mar 20 12:15:23: %DUAL-3-SIA: Route 10.1.1.0/24 stuck-in-active state in IP-EIGRP 1.
Cleaning up
The network administrator issued the show ip eigrp topology active command on R2 to check the status of the EIGRP network. Which statement best describes the reason for the error messages?
Select the best response.
What could be the cause of the problem?
Refer to the exhibit. EIGRP has been configured on routers R1 and R2. However, R1 does not show R2 as a neighbor and does not accept routing updates from R2. What could be the cause of the problem?
Select the best response.
What configuration should be done on the routers in autonomous system 100
Refer to the exhibit. Autonomous systems 200 and 300 have EBGP sessions established with their directly connected routers in autonomous system 100. IGP has been configured on all routers in autonomous system 100 and they successfully exchange routing updates. Traffic originated in autonomous system 200 cannot reach the destination autonomous system 300. What configuration should be done on the routers in autonomous system 100 in order for the traffic coming from autonomous system 200 to be forwarded to autonomous system 300?
Select the best response.
Which three path features would be reasons be for the router to ignore some of the routes
A router is running BGP and receives more than one route for a particular prefix.Assume all the routes for this prefix have the same attributes. Which three path features would be reasons be for the router to ignore some of the routes and not consider them as candidates for the best path? (Choose three.)
Select 3 response(s).
Which configuration change would ensure that R1 would receive a default route from R2?
Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as intended. Which configuration change would ensure that R1 would receive a default route from R2?
Select the best response.