What could be the cause of this problem?
You have completed an OSPF implementation, and you are verifying OSPF operation. During this verification, you notice that the OSPF route of 172.16.10.0 is repeatedly appearing and disappearing from the routing table. Further investigation finds that the OSPF CPU utilization is very high and the routers are constantly performing SPF calculations. You determine that 172.16.20.2 is the source of the 172.16.10.0 route. Using the show ip ospf database router 172.16.20.1 command, you notice that when this show command is performed repeatedly, the contents of the LSA change every few seconds.
What could be the cause of this problem?
Select the best response.
What could be the cause of this problem?
You have just completed an OSPF implementation. While executing your verification plan, you determine that R1 is not able to establish full OSPF adjacency with R2. The show ip ospf neighbor command output on R1 shows that R2 is stuck in the INIT state.
What could be the cause of this problem?
Select the best response.
Which statement is true about OSPF Network LSAs?
Which statement is true about OSPF Network LSAs?
Select the best response.
What is the next thing that should be checked?
When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful. What is the next thing that should be checked? Select the best response.
which statement describes the configuration of OSPF areas?
When implementing OSPFv3, which statement describes the configuration of OSPF areas? Select the best response.
which statement is correct regarding the redistribution of routes from other routing protocols into OSPF?
By default, which statement is correct regarding the redistribution of routes from other routing protocols into OSPF?
Select the best response.
Which two routing protocols require a metric to be configured when redistributing routes from other protocols?
Which two routing protocols require a metric to be configured when redistributing routes from other protocols? (Choose two.)
Select 2 response(s).
Which option indicates a possible reason this command did not cause the router to advertise the aggregate netw
During BGP configuration on a router that has peered with other BGP speakers, the BGP command aggregate-address 172.32.0.0 255.255.252.0 is issued. However, the peers do not receive this aggregate network in BGP advertisements. Also, the router does not have this aggregate network in its BGP table. Which option indicates a possible reason this command did not cause the router to advertise the aggregate network to its peers? Select the best response.
What two situations could require the use of multiple routing protocols?
What two situations could require the use of multiple routing protocols? (Choose two) Select 2 response(s).
how can the address 2031:0000:240F:0000:0000:09C0:123A:121B be rewritten?
Using the rules for IPv6 addressing, how can the address 2031:0000:240F:0000:0000:09C0:123A:121B be rewritten? Select the best response.