PrepAway - Latest Free Exam Questions & Answers

Category: 642-902 (v.2)

Exam 642-902: Implementing Cisco IP Routing (update September 20th, 2014)

which command should be added, or edited, on router B1 under router ospf 10?

Refer to the exhibit.

The network administrator is trying to configure mutual redistribution between
EIGRP and OSPF. Autosummarization in EIGRP 100 AS is disabled. After adding OSPF
configuration to router B1, the network administrator checked the routing table of router B2, but
none of the EIGRP routes appeared there.
To redistribute the EIGRP AS 100 routes into OSPF, which command should be added, or edited,
on router B1 under router ospf 10?

which answer lists an appropriate comment to be made during the implementation plan peer review?

An engineer has added the following configuration snippet to an implementation planning
document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN
to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each
other. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which
answer lists an appropriate comment to be made during the implementation plan peer review?
key chain fred
key 3
key-string whehew
interface fa0/0
ip authentication key-chain eigrp 9 fred

Which dynamic routing protocol should be deployed in your network to best meet these requirements?

Based on the need to limit processing and bandwidth utilization due to dynamic routing protocol
operation, the following routing requirements have been specified for your network.
– Partial and incremental routing updates
– Only the devices affected by a topology change perform route recomputation
– Route recomputation only occurs for routes that were affected

Which dynamic routing protocol should be deployed in your network to best meet these
requirements?

What can be done so that data will be routed along the most optimal path in the network?

Refer to the exhibit.

Router B and router C are performing mutual redistribution between OSPF
and EIGRP, and their default metrics are configured the same. Router D has equal cost paths to
networks where both paths are not really equal cost. For example, network 172.16.54.0 shows

equal cost through both router B and router C, though in reality the cost is greater using router C.
Other routers, though not shown, are connected to the 172.16.54.0 and 172.16.55.0 networks, and
the same issues exist to those routers and the networks connected to them. What can be done so
that data will be routed along the most optimal path in the network?


Page 7 of 38« First...56789...2030...Last »