what three configurationchanges might you make?
Which BGP feature should be used to avoid high memory utilization on a router?
Which BGP feature should be used to avoid high memory utilization on a router? Select the
best response.
Which BGP option is required when load sharing overmultiple equal-bandwidth parallel links from a single CE ro
Which BGP option is required when load sharing overmultiple equal-bandwidth parallel
links from a single CE router to a single ISP router over eBGP? Select the best response.
Why are the EIGRP neighbors for this router not learning the routes redistributed from OSPF?
Refer to the exhibit. Why are the EIGRP neighbors for this router not learning the routes
redistributed from OSPF? Select the best response.
router eigrp 123
redistribute ospf 123
network 116.16.35.0 0.0.0.255
network 130.130.0.0
auto-summary
!
router ospf 123
log-adjacency-changes
network 116.16.34.0 0.0.0.255 area 0
neighbor 116.16.34.4
Why is the 140.140.0.0 network not used as the gateway of last resort even though it is configured first?
Refer to the exhibit. Why is the 140.140.0.0 network not used as the gateway of last resort
even though it is configured first? Select the bestresponse.
R3#show run | include defaultip default-network 140.140.0.0
ip default-network 130.130.0.0
R3#show ip route | begin Gateway
Gateway of last resort is 0.0.0.0 to network 130.130.0.0
116.0.0.0/8 is variably subnetted, 5 subnets, 3 masks
C 116.16.37.0/30 is directly connected, Serial1/0.2
C 116.16.32.0/30 is directly connected, Serial2/0.2
C 116.16.34.0/28 is directly connected, Serial1/0.1
C 116.16.35.0/28 is directly connected, Serial2/0.1
S 116.0.0.0/8 [1/0] via 116.16.34.0
* 140.140.0.0/32 is subnetted, 3 subnets
O 140.140.1.1 [110/65] via 116.16.34.4, 00:14:54, Serial1/0.1
O 140.140.3.1 [110/65] via 116.16.34.4, 00:14:54, Serial1/0.1
O 140.140.2.1 [110/65] via 116.16.34.4, 00:14:54, Serial1/0.1
* 130.130.0.0/16 is variably subnetted, 4 subnets, 2 masks
D* 130.130.0.0/16 is a summary, 00:30:04, Null0
C 130.130.1.0/24 is directly connected, Ethernet0/0
C 130.130.2.0/24 is directly connected, Ethernet0/1
C 130.130.3.0/24 is directly connected, Ethernet1/0
D 150.150.0.0/16 [90/679936] via 116.16.35.5, 00:02:58,
Serial2/0.1
what is the correct order of events when there is a FS?
When an EIGRP topology change is detected, what is the correct order of events when
there is a FS? Select the best response.
Which statement about the selectionof a dynamic protocol is true?
Your network consists of a large hub-and-spoke Frame Relay network with a CIR of 56 kb/s
for each spoke. Which statement about the selectionof a dynamic protocol is true? Select
the best response.
Which statement about a non-zero value for the loadmetric (k2) for EIGRP is true?
Which statement about a non-zero value for the loadmetric (k2) for EIGRP is true? Select
the best response.
Which dynamic routing protocol should be deployed in your network to best meet these requirements?
Based on the need to limit processing and bandwidthutilization due to dynamic routing
protocol operation, the following routing requirements have been specified for your network.
– partial and incremental routing updates
– only the devices affected by a topology change perform route recomputation
– route recomputation only occurs for routes that were affected
Which dynamic routing protocol should be deployed in your network to best meet these
requirements? Select the best response.
Which condition must be satisfied before an EIGRP neighbor can be considered a feasible successor?
Which condition must be satisfied before an EIGRP neighbor can be considered a feasible
successor? Select the best response.