Refer to the exhibit. Routers RTA and RTB are running BGP but the session is active. What
command needs to be added to establish the BGP session?

EIGRP has been configured to operate over Frame Relay multipoint connections. What
should the bandwidth command be set to?

Study the configuration presented in the exhibit carefully. What is the objective of the route
map named test?
router bgp 50001
network 10.0.0.0
network 172.16.0.0
neighbor 10.1.1.1 remote-as 5003
neighbor 10.1.1.1 route-map test out
!
access-list 1 permit 10.0.0.0
access-list 2 permit any
!
route-map test permit 10
match ip address 1
set metric 200
!
route-map test permit 20
match ip address 2

When learning a new route, if a LSA received is notfound in the topological database, what
will an internal OSPF router do?

One of the most important characteristics of OSPF is Multiple areas. Which statement best
describes why this feature is such an important enhancement to earlier routing protocols?

During the redistribution process configured on RTA, some of the EIGRP routes, such as
10.1.1.0/24 and 10.2.2.0/24, are not being redistributed into the OSPF routing domain.
Which two items could be a solution to this problem? (Choose two.)

Which option is true regarding the synchronization rule?

Refer to the exhibit. The actual speed of the serial links between R2 and R3 are 256 kb/s
and 512 kb/s respectively. When configuring EIGRP on routers R2 and R3, the network
administrator configured the bandwidth of both serial interfaces to 512 kb/s.
What will be the effect?

Refer to the exhibit. All routers are configured for BGP. EBGP routes received on router R2
show up in the BGP table on routers R1 and R3 but not in their IP routing tables. What
would cause this (Choose two) ?

Based on the topology shown in the network diagram,what optional EIGRP configurations
will be required in order to achieve full connectivity within AS 100?