BGP contains two paths to a destination. Assuming both routes were originated locally and
have an equal weight. what will be the next determining factor in choosing the best path?

Refer to the exhibit. Router RTR is attempting to establish BGP neighbor relationshis with
routers RT1 and RT3. On the basis of the information that is presented in the exhibit, which
two statements are true? (Choose two)

Refer to the exhibit. What must be configured on router RTA to summarize all routes from
area 0 to area 1?

What are three IPv6 transition mechanisms? (Choose three)

You need to explain the differences between an IPv4header and an IPv6 header. In this
comparison, which three statements are true? (Choose three)

Which statement describes the difference between a manually configured IPv6 in IPv4
tunnel versus an automatic 6to4 tunnel?

Which two statements are true about using IPv4 and IPv6 simultaneously on a network
segment? (Choose two.)

Refer to the exhibit. Routers R1 and R2 are IPv6 BGP peers that have been configured to
support a neighbor relationship over an IPv4 internetwork.
Which three neighbor IP addresses are valid choicesto use in the highlighted section of the
exhibit? (Choose three.)

Refer to the exhibit. Routers R1 and R2 have established a neighbor relationship and are
exchanging routing information. The network design requires that R1 receive routing
updates from R2, but not advertise any routes to R2. Which configuration command
sequence will successfully accomplish this task?

When policy-based routing (PBR) is being configured, which three criteria can the set
command specify? (Choose three.)