A network administrator enters the following switch commands:
Switch(config)#interface range fa0/0-5
Switch(config-if-range)#switchport access vlan 2
What is the result of these commands?

When a VLAN port configured as a trunk receives an untagged frame, what will happen?

By default, which statement is correct when an IEEE 802.1Q trunk port receives an untagged
frame?

Refer to the exhibit.

Both host stations are part of the same subnet but are in different VLANs. On the basis of the
information presented in the exhibit, which statement is true about an attempt to ping from host to
host?

Refer to the exhibit.

VLAN 1 and VLAN 2 are configured on the trunked links between Switch A
and Switch B. Port Fa 0/2 on Switch B is currently in a blocking state for both VLANs. What
should be done to load balance VLAN traffic between Switch A and Switch B?

Refer to the exhibit.

What information can be derived from the output?

What are three results of issuing the switchport host command? (Choose three.)

Refer to the exhibit.

All links in this network are layer 2, fast Ethernet 100 Mb/s and operating as trunks. After a failure,
the link between ASW-1 and DSW-1 has incorrectly come back up at 10Mb/s although it is
connected.
Which one of the following will occur as a result of this failure?

What is the result of entering the command spanning-tree loopguard default?

What is the effect of applying the switchport trunk encapsulation dot1q command to a port on a
Cisco Catalyst switch?