Which First Hop Redundancy protocol cannot be configured for interface tracking?

Which high availability service is verified by the show standby command?

Observe the topology in the exhibit. HSRP is configured between RTB and RTC with RTC as the
active router. SW2 is configured as the root bridge for the Spanning Tree Protocol. What will
happen if the serial connection on RTC is down?

What is the maximum number of HSRP standby groups that can be configured on a Cisco router?

Refer to the exhibit.

What statement is true based upon the configuration of router R1 and router
R2?

Refer to the exhibit.

Routers R1 and R2 are configured in an HSRP group to provide redundancy
for the users on Network A. The T1 link between R1 and Network B has failed. How will HSRP
respond to the failure?

Refer to the exhibit.

HSRP has been configured and Link A is the primary route to router R4.
When Link A fails, router R2 (Link B) becomes the active router. Which router will assume the
active role when Link A becomes operational again?

Refer to the exhibit.

Which two sets of procedures are best practices for Layer 2 and 3 failover
alignment? (Choose two.)

Which two statements about HSRP priority are true? (Choose two.)

Which two items are most important for managing the long-term success of high availability?
(Choose two.)