Organize the levels by dragging each name from the left to the right.
Put the highest level at the top and lowest at the bottom.

Prioritize the traffic types by dragging them from the left to the appropriate Cisco priority level onthe right. Put
the highest priority at the top and lowest priorityat the bottom.

Place the DTP mode with its correct description.

Drag the items to the proper locations.

Drag the attributes on the left to the types on VLAN designs that they describe on the right.

Drag the steps from the left to the right that should be part of the verification plan.

Drag the port sates to their correct description.

Categorize the high availability network resources or feature items on the left by dragging them to appropriate
resiliency or management level on the right.

During routine maintenance, GigabitEthernet1/0/1 onDSW1 was shut down. All other interfaces were up.
DSW2 became the active HSRP device for VLAN 101 as desired. However, after GigabitEthernet1/0/1 on
DSW1 was reactivated, DSW1 did not become the active router for VLAN 101 as desired. What needs to be
done to make the group for VLAN 101 function properly?

During routine maintenance, it became necessary to shut down the GigabitEthernet1/0/1 interface on DSW 1.
All other interfaces were up. During this time DSW1remained the active device for the VLAN 102 HSRP group.
You have determined that there is an issue with thedecrement value in the track command for the VLAN 102
HSRP group. What need to be done to make the group function properly?