What is the maximum number of HSRP standby groups that can be configured on a Cisco router?
What is the maximum number of HSRP standby groups that can be configured on a Cisco router?
What is the method used to filter traffic being bridged within a VLAN?
What is the method used to filter traffic being bridged within a VLAN?
Which trunking protocol inserts a four byte tag into the Ethernet frame and recalculates the CRC value?
Which trunking protocol inserts a four byte tag into the Ethernet frame and recalculates the CRC value?
what will happen?
When a VLAN port configured as a trunk receives an untagged frame, what will happen?
Which high availability service is verified by the show standby command?
Which high availability service is verified by the show standby command?
What is the result of these commands?
A network administrator enters the following switchcommands:
Switch (config)#interface range fa0/0-5
Switch(config-if-range)#switchport access vlan 2
What is the result of these commands?
Drag the steps from the left to the right that should be part of the verification plan.
Drag the steps from the left to the right that should be part of the verification plan.
Drag the port sates to their correct description.
Drag the port sates to their correct description.
Categorize the high availability network resources or feature items on the left by dragging them to appropriat
Categorize the high availability network resources or feature items on the left by dragging them to appropriate
resiliency or management level on the right.
What needs to be done to make the group for VLAN 101 function properly?
During routine maintenance, GigabitEthernet1/0/1 onDSW1 was shut down. All other interfaces were up.
DSW2 became the active HSRP device for VLAN 101 as desired. However, after GigabitEthernet1/0/1 on
DSW1 was reactivated, DSW1 did not become the active router for VLAN 101 as desired. What needs to be
done to make the group for VLAN 101 function properly?