Which two statements about HSRP priority are true? (Choose two)

Refer to the exhibit. Which two sets of procedures are best practices for Layer2 and 3 failover alignment?
(Choose two)

What three tasks will a network administrator perform to successfully configure Hot Standby Routing Protocol?
(Choose three)

Which two items are most important for managing thelong-term success of high availability? (Choose two)

Refer to the exhibit. VLAN 1 and VLAN 2 are configured on the trunked links between Switch A and Switch B.
Port Fa 0/2 on Switch B is currently in a blocking state for both VLANs. What should be done to load balance
VLAN traffic between Switch A and Switch B?

Given the configurations on SwitchA and SwitchB, which statement is true?

Observe the topology in the exhibit. HSRP is configured between RTB and RTC with RTC as the active router.
SW2 is configured as the root bridge for the Spanning Tree Protocol. What will happen if the serial connection
of RTC is down?

Refer to the exhibit. What statement is true based upon the configuration of router R1 and router R2?

Which First Hop Redundancy protocol cannot be configured for interface tracking?

Refer to the exhibit and the partial configuration on router R1 and R2. Hot Standby Routing Protocol (HSRP) is
configured on the network to provide network redundancy for the IP traffic. The network administrator noticed
that R2 does not became active when the R1 serial0 interface goes down. What should be changed in the
configuration to fix the problem?