Refer to the exhibit.

Assume that Switch_A is active for the standby group and the standby device has only the
default HSRP configuration. Which statement is true?

Refer to the exhibit.

GLBP has been configured on the network. When the interface serial0/0/1 on router R1 goes
down, how is the traffic coming from Host1 handled?

Refer to the exhibit and the partial configuration on routers R1 and R2.

HSRP is configured on the network to provide network redundancy for the IP traffic. The
network administrator noticed that R2 does not become active when the R1 serial0 interface
goes down. What should be changed in the configuration to fix the problem?

The following command was issued on a router that is being configured as the active HSRP
router.
standby ip 10.2.1.1
Which statement about this command is true?

hostname Switch1
interface Vlan10
ip address 172.16.10.32 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 700

standby 1 preempt
hostname Switch2
interface Vlan10
ip address 172.16.10.33 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 750
standby 1 priority 110
standby 1 preempt
hostname Switch3
interface Vlan10
ip address 172.16.10.34 255.255.255.0
no ip redirects
standby 1 ip 172.16.10.110
standby 1 timers msec 200 msec 750
standby 1 priority 150
standby 1 preempt
Refer to the above. Three switches are configured for HSRP.
Switch1 remains in the HSRP listen state. What is the most likely cause of this status?

Three Cisco Catalyst switches have been configured with a first-hop redundancy protocol.
While reviewing some show commands, debug output, and the syslog, you discover the
following information:
Jan 9 08:00:42.623: %STANDBY-6-STATECHANGF. Standby: 49:
Vlan149 state Standby -> Active
Jan 9 08:00:56.011: %STANDBY-6-STATECHANGF. Standby: 49:
Vlan149 state Active -> Speak
Jan 9 08:01:03.011: %STANDBY-6-STATECHANGF. Standby: 49:
Vlan149 state Speak -> Standby
Jan 9 08:01:29.427: %STANDBY-6-STATECHANGF. Standby: 49:
Vlan149 state Standby -> Active
Jan 9 08:01:36.808: %STANDBY-6-STATECHANGF. Standby: 49:
Vlan149 state Active -> Speak
Jan 9 08:01:43.808: %STANDBY-6-STATECHANGF. Standby: 49:
Vlan149 state Speak -> Standby
What conclusion can you infer from this information?

Refer to the exhibit.

Which statement best describes first-hop redundancy protocol status?

Which two statements correctly describe VTP? (Choose two.)

Which two DTP modes permit trunking between directly connected switches? (Choose two.)

Which two RSTP port roles include the port as part of the active topology? (Choose two.)