Which well-defined routing protocol would a network administrator configure on multicast routers
when member routers are widely dispersed?

Refer to the exhibit and the partial configuration on routers R1 and R2. Hot Standby Routing
Protocol (HSRP) is configured on the network to provide network redundancy for the IP traffic. The
network administrator noticed that R2 does not became active when the R1 serial0 interface goes
down. What should be changed in the configuration to fix the problem?

What must be configured on a Cisco switch in order to advertise VLAN information?

Which command sequence is required to configure the IP address of the rendezvous point (RP)
located at IP address 10.10.10.1?

Refer to the exhibit. Which two statements are true about the output from the show standby vlan
50 command? (Choose two.)

Which enhancement was added to IGMP version 3?

Which option correctly identifies the Cisco IOS switching methods in descending order from the
fastest method to the slowest method?

Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct
command set to configure LACP on Switch2?

Which type of IGMP message is sent when a network client wants to join a multicast group?

Refer to the exhibit. Supervisor redundancy has been configured on a Catalyst 4500 switch. The
administrator issued the show redundancy states command. Which two statements are true about
the output? (Choose two.)