DRAG DROP
Drag from the left the material type, and drop it under its relative attenuation level on the right.

DRAG DROP
Drag from the left the maximum power, and drop it under appropriate UNII channel band regarding the FCC domain when designing and deploying outdoor WLAN using 5 Ghz.

DRAG DROP
Drag from the left the acceptable minimum cell overlap for data and voice cells for site survey and deployment.

DRAG DROP
Drag from the left the minumum requirements needed for a location based survey and deployment and drop them on the right.

DRAG DROP
Drag from the left the preferred parameters without excess for location service survey and deployment, and drop them on the right.

When performing a post-installation audit using the Ekahau Survey tool, which four steps are
associated with the passive portion of the audit? (Choose four.)

When designing a WLAN, AP placement is important. How would you rank the density of APs
needed to support location services versus data and voice services?

When designing for location services, how many APs should be heard by each location-ready AP
and at what dBm signal level? (Choose two.)

A Cisco 1250 AP is deployed for a/b/g/n using version 7.0 software on 802.3af PoE. What are the
three deployment results of the 5 GHz radio on channel size, spatial stream, and data rate?
(Choose three.)

Refer to the exhibit.

What is the most likely cause of MAP1 association to MAP2 instead of directly to the RAP?