A network sniffer is implemented to troubleshoot call setup failures. Initially, the sniffer is able to
see only traffic sent to and from the computer that is running the sniffer.
Which two solutions allow the sniffer to see H.323 call setup traffic to and from different devices
other than the computer that is running the sniffer. (Choose two.)

Which troubleshooting tool is the most effective in parsing the large traces of call setup on many
Cisco IP Phones that are registered in a Cisco Unified Communications Manager cluster to just
two Cisco IP Phones?

Some users report that they cannot dial out from headquarters on their Cisco IP Phones to PSTN
users, but others can.
Which troubleshooting approach is the most direct to isolate the source of the failure of the users
that cannot dial out to the PSTN?

Which Cisco troubleshooting tool allows syslog logs to be viewed?

Which three troubleshooting tools are available on Cisco Unified Communications Manager?
(Choose three.)

Which tool or approach is the most effective to display detailed real-time output of CPU utilization
of Cisco Unified Communications Manager servers for troubleshooting purposes?

Several Cisco 7961 IP Phones were initially registered to a Cisco Unified Communications
Manager cluster that is enabled with SRTP and TLS. When the same phones are moved to a new
Cisco Unified CM cluster, the phones are not registering to the new Cisco Unified CM cluster.
Which action can be taken to solve this problem?

You have been advised by a TAC engineer to update the firmware of your Cisco IP Phones in your
Cisco Unified Communications Manager cluster. You must update just one test phone initially in
production to test the new firmware before you update the other production phones.

Which action allows this process without any down time to the other production phones?

Refer to the exhibit.

A second Cisco Unified Communications Manager server of 10.10.10.101 was added along with
the existing Cisco Unified CM server of 10.10.10.100. When Cisco Unified CM 10.10.10.100 is
unavailable, the branch gateway fails to register.

Which configuration change is needed to register the gateway to either Cisco Unified CM server?

After you provision a new H.323 gateway to integrate with a Cisco Unified Communications
Manager cluster, you see that the H.323 gateway shows unregistered in Cisco Unified CM.
Which action is needed to register the H.323 gateway with Cisco Unified Communications
Manager?