A network operations team needs to monitor the health of Cisco Nexus switches. Which type of
UDP-based protocol should be configured on these devices for management and monitoring?

Which protocol is supported when OSPFv2 is used as the routing protocol?

What is the maximum distance for 100Base-TX?

What is the result when two data transmissions are sent at the same time?

There is a large amount of traffic inside a network segment with a destination address of
FF:FF:FF:FF:FF:FF. What type of traffic uses this address?

What two commands are used to modify the MAC Table? (Choose two.)

Which situation will cause a switch to flood traffic out all of the ports on the switch?

A network engineer notices that the MAC address table on a network switch is full. What type of
Layer 2 network behavior will occur while the network MAC address table remains full?

A network engineer is tasked with installing a new switch into the network access layer. The switch
needs to see VTP data, but does not need to participate in the VTP domain. What VTP mode
should the switch be configured for?

What are two valid VTP commands? (Choose two.)