What does the command ‘rep admin vlan 100’ accomplish?

After configuring Q-in-Q on a new interface, the customer has requested that the IOS version and
remote model also be viewable via the trunk. What additional command would need to be applied
to both sides of the Q-in-Q trunk?

Refer to the exhibit.

What additional configuration is required to enable inter-VLAN routing for VLANs 10 and 20 on the
Cisco ME 3400 switch using the Metro IP Access image?

What three statements about REP configurations on a Cisco ME 3400 switch port are true?
(Choose three.)

Refer to the configuration output below. OSPFv2 is already configured on a customer router and
the customer is requesting that OSPFv3 be added. What configuration is needed in order to add
OSPFv3 to the fastethernet0/0 interface?
Configuration:
ipv6 router ospf 1
router-id 209.165.200.227
area 2 nssa
interface fastethernet0/0
ip address 2001:DB8:0:7::

What is the foundation architecture of Cisco Next Generation Networks?

Refer to the configuration snippet below. A new IOS-XR router is being added to the network.
What command is required to enable the Label Distribution Protocol on interface GigabitEthernet
0/3/0/0?
Configuration:
mpls ldp
router-id 209.165.200.226

Refer to the exhibit.

A network engineer implemented these configurations. However, Intermediate System-toIntermediate System (IS-IS) neighbors are unable to establish. What is the reason for this error?

Which three are examples of a link-state routing protocols and static routing? (Choose three.)

Refer to the exhibit.

A new customer is not receiving routes from the Provider Edge router. What command needs to
be added to advertise routes?