Which statement identifies a benefit obtained when using a top-down network design plan?

Lightweight access points are being deployed in remote locations where others are already
operational. The new access points are in a separate IP subnet from the wireless controller. OTAP
has not been enabled at any locations. Which two methods can the AP use to locate a wireless
controller? (Choose two.)

Which Cisco security solution can quarantine and prevent non-compliant end stations from
accessing the network until they achieve security policy compliance?

A network design includes private addressing, but there is also a need for two or three network
devices to each be assigned a unique public address so they can be accessed from the Internet.
Which technique will satisfy this requirement?

A Cisco security mechanism has the following attributes:
it is a sensor appliance
it searches for potential attacks by capturing and analyzing traffic
it is a “purpose-built device”
it is installed passively
it introduces no delay or overhead
Which Cisco security mechanism is this?

Which two routing protocols operate over NBMA point-to-multipoint networks without the use of
point-to-point subinterfaces? (Choose two.)

Which three types of WAN topologies can be deployed in the Cisco Enterprise Architecture
Enterprise Edge WAN module? (Choose three.)

Which statement accurately describes one difference between a small office and medium office
topology?

Which of these is the best routing deployment for a single dedicated link to an ISP for Internet
access?

Refer to the exhibit. Which two statements correctly identify the layers of the Enterprise Campus
module? (Choose two.)