Refer to the exhibit. Given the output from the show ip eigrp topology command, which router is
the feasible successor?

Refer to the exhibit.

You are connected to the router as user Mike. Which command allows you to see output from the
OSPF debug command?

Refer to the exhibit.

Host A has tested connectivity to a remote network. What is the default gateway for host A?

Refer to the exhibit.

What is the result of setting the no login command?

What does the “Inside Global” address represent in the configuration of NAT?

Refer to the graphic.

A company wants to use NAT in the network shown. Which commands will apply the NAT
configuration to the proper interfaces? (Choose two.)

Refer to the exhibit.

A network technician enters the following lines into the router.
Tidmore1(config)# interface FastEthernet 0/0
Tidmore1(config-if)# no ip access-group 106 in
Tidmore1(config-if)# interface Serial 0/0
Tidmore1(config-if)# ip access-group 106 out
What is the effect of this configuration?

Refer to the exhibit.

Router4 can ping Router5 (172.16.6.5), but not Router7 (172.16.11.7). There are no routing
protocols running in any of the routers, and Router4 has Router6 as its default gateway. What can
be done to address this problem?

A network engineer wants to allow a temporary entry for a remote user with a specific username
and password so that the user can access the entire network over the Internet. Which ACL can be
used?

What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when
configuring a Frame Relay hub in a hub-and-spoke topology?