what is the cause of the failure?
Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network.
The network administrator connected to router Coffee via the console port, issued the show ip
route command, and was able to ping the server.
Based on the output of the show ip route command and the topology shown in the graphic, what is
the cause of the failure?
what is the most likely cause of the problem?
The network administrator has found the following problem.
The remote networks 172.16.10.0, 172.16.20.0, and 172.16.30.0 are accessed through the
Central router’s serial 0/0 interface.
No users are able to access 172.16.20.0. After reviewing the command output shown in the
graphic, what is the most likely cause of the problem?
which option contains both the potential networking problem and the protocol or setting that should be used to
Refer to Exhibit:
Based on the network shown in the graphic which option contains both the potential networking
problem and the protocol or setting that should be used to prevent the problem?
What information does a router running a link-state protocol use to build and maintain its topological databas
What information does a router running a link-state protocol use to build and maintain its
topological database? (Choose two.)
Which statements describe the routing protocol OSPF?
Which statements describe the routing protocol OSPF? (Choose three.)
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VL
Which protocol reduces administrative overhead in a switched network by allowing the
configuration of a new VLAN to be distributed to all the switches in a domain?
what configuration error is causing this problem?
A network administrator is trying to add a new router into an established OSPF network. The
networks attached to the new router do not appear in the routing tables of the other OSPF routers.
Given the information in the partial configuration shown below, what configuration error is causing
this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0
which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s.
The addressing scheme for each company site is as follows:
Router Ethernet port – 1st usable address
Core – 2nd usable address
Core2 – 3rd usable address
For this network, which of the following commands must be configured on Core2 to allow it to be
managed remotely from any subnet on the network? (Choose three.)
what value does a router use for the OSPF router ID in the absence of a loopback interface?
If all OSPF routers in a single area are configured with the same priority value, what value does a
router use for the OSPF router ID in the absence of a loopback interface?
which of the following tasks?
The OSPF Hello protocol performs which of the following tasks? (Choose two.)