CORRECT TEXT
Lab- CLI
Central Florida Widgets recently installed a new router in their office. Complete the network
installation by performing the initial router configurations and configuring R1PV2 routing using the
router command line interface (CLI) on the RC.
Configure the router per the following requirements:
Name of the router is R2

Enable. secret password is cisco
The password to access user EXEC mode using the console is cisco2
The password to allow telnet access to the router is cisco3
IPV4 addresses mast be configured as follows:
Ethernet network 209.165.201.0/27 – router has fourth assignable host address in subnet
Serial network is 192.0.2.176/28 – router has last assignable host address in the subnet.
Interfaces should be enabled.
Router protocol is RIPV2
Attention:
In practical examinations, please note the following, the actual information will prevail.
1. Name of the router is xxx
2. Enable. secret password is xxx
3. Password In access user EXEC mode using the console is xxx
4. The password to allow telnet access to the router is xxx
5. IP information

On point-to-point networks, OSPF hello packets are addressed to which address?

A network administrator has configured two switches, named London and Madrid, to use VTP.
However, the switches are not sharing VTP messages. Given the command output shown in the
graphic

Why are these switches not sharing VTP messages?

While troubleshooting a network connectivity problem, a technician observes steady link lights on
both the workstation NIC and the switch port to which the workstation is connected. However,
when the ping command is issued from the workstation, the output message “Request timed out.”
is displayed. At which layer of the OSI model does the problem most likely exist?

When a packet is sent from Host 1 to Server1, in how many different frames will the packet be
encapsulated as it is sent across the internetwork?

The corporate head office has a teleconferencing system that uses VOIP(voice over IP)
technology. This system uses UDP as the transport for the data transmissions. If these UDP
datagrams arrive at their destination out of sequence, what will happen?

While troubleshooting a connectivity problem, a network administrator notices that a port status
LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this
indicate?

Refer to the exhibit. Switch-1 needs to send data to a host with a MAC address of 00b0.d056.efa4.
What will Switch-1 do with this data?

Please study the exhibit shown above carefully, and answer the following question.
Which connection user the default encapsulation for serial interfaces on Cisco routers?

Users on the 192.168.1.0/24 network must access files located on the Server1.What route could
be configured on router R1 for file requests to reach the server?