As a network technician, do you know which are valid modes for a switch port used as a VLAN
trunk? (Choose three.)

OSPF routing uses the concept of areas. What are the characteristics of OSPF areas? (Choose
Three.)

What information can be used by a router running a link-state protocol to build and maintain its
topological database? (Choose two.)

Which items are correct about the routing protocol OSPF? (Choose three.)

The switches shown in the diagram.
Core and Core2, are both Catalyst 2950s.
The addressing scheme for each company site is as follows:
Router Ethernet port: 1st usable address
CorE. second usable address
Core2: third usable address
For this network, which of the following commands must be configured on Core2 to allow it to be
managed remotely from any subnet on the network? (Choose three.)

An administrator is unsuccessful in adding VLAN 50 to a switch. While troubleshooting the
problem, the administrator views the output of the show vtp status command, which is displayed in
the graphic. What commands must be issued on this switch to add VLAN 50 to the database?
(Choose two.)

Which of the following IP addresses fall into the CIDR block of 115.64.4.0/22? (Choose three.)

Which of the following are types of flow control? (Choose three.)

Which destination addresses will be used by Host A to send data to Host C? (Choose two.)

Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down. Which of the
following are true? (Choose two.)