The network administrator has asked you to check the status of the workstation’s IP stack by
pinging the loopback address. Which address would you ping to perform this task?

Workstation A has been assigned an IP address of 192.0.2.24/28. Workstation B has been
assigned an IP address of 192.0.2.100/28. The two workstations are connected with a straightthrough cable. Attempts to ping between the hosts are unsuccessful. What are two things that
could be attempted that would allow communications between the hosts? (Choose two.)

Your ISP has given you the address 223.5.14.6/29 to assign to your router’s interface. They have
also given you the default gateway address of 223.5.14.7. After you have configured the address,
the router is unable to ping any remote devices. What is preventing the router from pinging remote
devices?

Which command is used to copy the configuration from RAM into NVRAM?

Which command is used to load a configuration from a TFTP server and merge the configuration
into RAM?

A system administrator types the command to change the hostname of a router. Where on the
Cisco IFS is that change stored?

Which command is used to configure a default route?

If IP routing is enabled, which two commands set the gateway of last resort to the default
gateway? (Choose two.)

Which command can enable CDP globally on the router and show the information about directly
connected Cisco devices?

Which command is used to see the path taken by packets across an IP network?