Refer to the exhibit. Based on the information given, which switch will be elected root bridge and
why?

Refer to the exhibit. S0/0 on R1 is configured as a multipoint interface to communicate with R2
and R3 in this hub-and-spoke Frame Relay topology. While testing this configuration, a technician
notes that pings are successful from hosts on the 172.16.1.0/24 network to hosts on both the
172.16.2.0/25 and 172.16.2.128/25 networks. However, pings between hosts on the 172.16.2.0/25
and 172.16.2.128/25 networks are not successful. What could explain this connectivity problem?

Why would a network administrator configure port security on a switch?

LAB
The task is to create and apply an access-list with no more than three statements that will allow ONLY host C web access to the Finance Web Server. No other hosts will have web access to the Finance Web Server. All other traffic is permitted.

Refer to the exhibit. A technician is testing connection problems in the internetwork. What is the
problem indicated by the output from HostA?

Refer to the exhibit. Two buildings on the San Jose campus of a small company must be
connected to use Ethernet with a bandwidth of at least 100 Mbps. The company is concerned
about possible problems from voltage potential differences between the two buildings. Which
media type should be used for the connection?

Refer to the exhibit. Switch1 sends a VTP advertisement and Switch2 receives it. Which statement
accurately describes how Switch2 will process this advertisement?

Refer to the exhibit. A network technician is asked to design a small network with redundancy. The
exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can
be made about this design?

Refer to the topology and partial router configurations shown in the exhibit. The network is fully
operational and all routing tables are converged. Which route will appear in the output of the show
ip route command issued on the Branch router?

DRAG DROP
As a member of the networking team, you must address the network and at the same time conserve unused addresses for future growth. With those goals in mind, drag the host addresses on the left to the correct router interface.