Refer to the exhibit. A technician is troubleshooting a host connectivity problem. The host is
unable to ping a server connected to Switch_A. Based on the results of the testing, what could be
the problem?

This graphic shows the results of an attempt to open a Telnet connection to router ACCESS1 from
router Remote27. Which of the following command sequences will correct this problem?

Refer to the exhibit. The network shown in the exhibit is running the RIPv2 routing protocol. The
network has converged, and the routers in this network are functioning properly. The
FastEthernet0/0 interface on R1 goes down. In which two ways will the routers in this network
respond to this change? (Choose two.)

Refer to the topology and partial switch command output shown in the graphic. The internetwork
shown in the diagram is experiencing connectivity problems. Host A is unable to ping Host B.
What needs to be done to enable these hosts to ping each another?

Refer to the exhibit. Based on the exhibited routing table, how will packets from a host within the
192.168.10.192/26 LAN be forwarded to 192.168.10.1?

A network administrator needs to configure a router for a Frame Relay connection to a non-Cisco
router. Which of the following commands will prepare the WAN interface for this connection?

Which destination addresses will be used by Host A to send data to Host C? (Choose two.)

Refer to the exhibit. The technician wants to upload a new IOS in the router while keeping the
existing IOS. What is the maximum size of an IOS file that could be loaded if the original IOS is
also kept in flash?

Refer to the exhibit. The network shown in the exhibit has just been installed. Host B can access
the Internet, but it is unable to ping host C. What is the problem with this configuration?

The EIGRP configuration in the Glencoe router uses a single network statement. From the output
shown in the graphic, which network statement would advertise these networks in EIGRP?