Refer to the exhibit.

A network administrator is configuring and installing an indoor mesh network using two CAPWAP
APs. The APs were out of the box and have already been installed in their designated locations.
The RAP is joined to the controller and configured appropriately, but the MAP is not visible on the
WLC. In the output shown, which of these explanations is the most likely reason for the issue?

Your customer is attempting to create two WLANs with identical SSIDs and identical Layer 2
security policies on their WLC 5508, without success. Which two of these actions would help
them? (Choose two.)

According to Cisco best practices, many features require the WLC to be synchronized with an
NTP server. For which of these options is time synchronization not required?

Refer to the exhibit.

The help desk informs you that some users cannot receive multicast video. Upon troubleshooting,
you determine that the users who are unable to receive the multicast video are all connected at 9
Mbps. Users that are connected at a data rate of 12 Mbps or higher are able to receive the
multicast video. Which data rate can you modify to fix the problem?

In order for MFP client protection to be required on the WLAN, which three of these requirements
must the client meet? (Choose three.)

Which of the following WLC feature is disabled by configuring the Passive Client feature?

Which two EAP methods are supported on H-REAP AP using a local RADIUS server? (Choose
two.)

You are attempting to use the Auto Provisioning feature in a Cisco WCS to apply the configuration
to a new WLC. Which options is not a valid method for identifying a WLC using the Auto
Provisioning feature?

Which three of these AP working modes is able to detect rogue access points over the air rather
than through the wired network? (Choose three.)

You are implementing Cisco CleanAir through the Cisco WCS without any MSE integration. Which
two types of data are you able to track through the Cisco WCS? (Choose two.)