Refer to the exhibit.

While troubleshooting a VoWLAN call quality issue on a Cisco Unified Wireless IP Phone 7925 on
a Cisco Unified Wireless Network, a network administrator views a compilation of outputs from the
WLAN settings and client connection status, as shown in the exhibit. From the information shown,
which one of these characteristics about the problem is true?

Refer to the exhibit.

A network administrator is troubleshooting a multicast problem in a Cisco Unified Wireless
Network topology. Which one of these groups of characteristics best describes the output shown
in the exhibit?

Which one of these options is not a valid reason for a client to become excluded?

Refer to the exhibit.

The corporate office has mandated that all guest WLAN users should have a per-user bandwidth
restriction. The requirement is 1 Mb/s for normal rate with a peak of 1.2 Mb/s. This is to be set for
HTTP traffic only. From the exhibit, showing the QoS properties for a current guest user
connection, is the above requirement met?

Refer to the exhibit.

A network administrator is troubleshooting a client connection and runs a debug client command
on the device MAC address. From the information in the exhibit, which explanation is correct?

Refer to the exhibit.

The customer intermittently sees these messages in the WLC message logs. Which two
sentences describe what these messages indicate? (Choose two.)

You are configuring WLC high availability for an access point. Which statement is true?

Refer to the exhibit.

A network administrator is troubleshooting a client connection problem. In the process of collecting
information, a client debug is run on the controller for the device MAC address. What is the most
likely cause of the problem?

A network administrator is troubleshooting a problem of a CAPWAP access point that
intermittently disconnects from the WLC. The administrator is trying to determine when the
problem is happening. UDP port 514 is allowed. What is the best option for successfully gathering
comprehensive information about the problem?

Refer to the exhibit.

You are testing the mesh AP feature in your lab. You begin by changing the AP mode from local to
bridge on one of your Cisco 3500 Series APs. The AP reboots and attempts to rejoin the
controller, but it fails to do so. Based upon the information in the exhibit, which two of these
options would allow the AP to join the WLC? (Choose two.)