What is the correct command to upgrade an autonomous AP to a Cisco Unified AP (Cisco IOS
Release 12.3(8)JEA2), after you established console access to the AP and set up a TFTP server
at 1.1.1.1?

Which three of these options are not valid ways to extend wireless coverage in an autonomous AP
environment? (Choose three.)

You are configuring an access point in a mobile scenario (on a train) which is connected to a L2
switch that has multiple clients attached. The access point must be configured to connect to the
mesh network. Which two of the below bridge configuration settings need to be configured?
(Choose two.)

Refer to the exhibit.

What does the max-channel 30 command refer to?

You are deploying a Cisco DMP (Digital Media Player) that only has an Ethernet interface, and
you plan to plug it into an access point to connect it to the Cisco Unified Wireless Network. The
DMP multicast video is displaying distorted and pixelated video. Which one of these radio interface
actions is most likely to improve the video stream quality?

Refer to the exhibit.

The autonomous AP has a corporate and guest SSID configured. The security team requested
that you limit guest user traffic to DHCP, DNS, and web browsing on the AP. Which configuration
best satisfies the request?

In the Cisco Unified Wireless Network (CUWN) model, which of the following mappings is correct
at the AP level?

You enabled CAC on your autonomous AP. Which two of these statements are true? (Choose
two.)

A network administrator is trying to convert a Cisco Aironet 1250 Series Lightweight Access Point
back to autonomous mode using a TFTP server and AP mode button. DHCP Option 43 is
configured, but the AP is not connected to the controller. Console and physical access to the AP
has been established. The TFTP server is local to the PC and the directory has the original image
of “c1250-k9w7-tar.124-10b.JDA3.tar,” downloaded from Cisco.com. The PC is directly connected
to the access point, but the conversion is failing. Which one of these statements is a possible
reason for the failure?

Company XYZ needs to establish network connectivity to a newly acquired, adjacent building less
than 1 kilometer (3280 feet) away. The project calls for implementing a wireless solution using
autonomous access points in a point-to-point bridging solution using external antennas on
interface dot11radio1. You need to secure the bridge link with strong EAP, DOT1x, and WPA
methods, using a local RADIUS server. However, the link cannot be established and the following
message is observed in the logs: “DOT1X_SHIM-3-SUPP_START_FAIL: Unable to start
supplicant on Dot11Radio1.” What is most likely the root cause?