Which two statements about virtual interfaces on a WLC are true? (Choose two.)

Refer to the exhibit.

Which EAP type does the diagram illustrate?

Which statement describes the operation of an access point in Rogue Location Discovery Protocol
mode?

Refer to the exhibit.

You want to use 3500e APs to setup an indoor mesh deployment. After you change the AP mode,
the AP will not rejoin the Cisco WLC. Which debug command was run, according to the exhibit, and
why is the AP not rejoining the Cisco WLC?

When you configure channel bonding on your APs by using the 2.4-GHz radio, what is the maximum
number of APs that you can place in a given location so that the AP channels do not overlap?

You calculate that your AP should transmit at 6 dBm to provide appropriate wireless coverage, while
still complying with EIRP, with the antennas that you selected. However, the AP is transmitting at 1
dBm only, even though it is on power level 1. How can you increase the transmitting power?

AP A is in AP group ONE and AP B in is AP group TWO. AP group ONE assigns the interface Marketing
to the corporate WLAN, whereas AP group TWO assigns the interface Sales to the same WLAN. What
happens if a client roams from AP A to AP B while connected to the corporate SSID?

What does disabling broadcast SSID in the WLAN configuration do?

What does RLDP do?

You are designing a wireless guest anchoring solution for a large company. Forty-five Cisco WLCs
running 7.0.116.0 code are deployed in the corporate network. You expect about 3000 devices to
use the guest network at any one time. A junior wireless administrator has suggested using a single
4402-12 WLC running 7.0.116.0 as the anchor controller. What is your response?