You are trying to set up a site-to-site IPsec tunnel between two Cisco ASA adaptive
security appliances, but you are not able to pass traffic. You try to troubleshoot the
issue by enabling debug crypto isakmp and see the following messages:
CiscoASA# debug crypto isakmp
[IKEv1]: Group = 209.165.200.231, IP = 209.165.200.231, Tunnel RejecteD. Conflicting
protocols specified by tunnel-group and group-policy
[IKEv1]: Group = 209.165.200.231, IP = 209.165.200.231, QM FSM error (P2 struct
&0xb0cf31e8, mess id 0x97d965e5)!
[IKEv1]: Group = 209.165.200.231, IP = 209.165.200.231, Removing peer from
correlator table failed, no match!
What could be the potential problem?

When you work on a change-management process, you generally identify potential
change, review the change request, implement change, then review the change and
close the process. In which step should the stakeholder be involved?

Many guidelines can be used to identify the areas that security policies should cover. In
which four areas is coverage most important? (Choose four.)

Refer to the exhibit.

Based on the show command output, which statement is true?

Interface tunnel 1
ip address 10.1.1.1 255.255.255.252
ip mtu 1400
Tunnel source 172.16.1.1
Tunnel destination 172.16.1.2
Tunnel key 1111
Based on the above configuration, if the input packet size is 1300 bytes, what is the size
of the packet leaves the tunnel after encapsulation?

You run the show ipv6 port-map telnet command and you see that the port 23 (systemdefined) message and the port 223 (user-defined) message are displayed. Which
command is in the router configuration?

At the end of the Cisco TrustSec authentication process, which three pieces of
information do both authenticator and supplicant know? (Choose three.)

You are preparing Control Plane Protection configurations for implementation on the
router, which has the EBGP peering address 1.1.1.2. Which ACL statement can you use
to classify the related traffic into the EBGP traffic compartment?

Which command enables fast-switched PBR?

Which of these configurations shows how to configure MPP when only SSH, SNMP, and
HTTP are allowed to access the router through the Gigabit Ethernet 0/3 interface and
only HTTP is allowed to access the router through the Gigabit Ethernet 0/2 interface?