Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite
links always have the same routing metric. The network administrator sees only the top routers
and links being used by hosts at both LAN A and LAN B. What would be two suggestions to loadbalance the traffic across both WAN links? Choose two.

Refer to the exhibit. What type of issue does this error log indicate if the IP address in the error log
is located off of the Router A WAN?

Refer to the exhibit.

If the router that produced the output in the exhibit fails, which virtual IP address will become
active when the router recovers?

Refer to exhibits 1 and 2. In exhibit 1, all users on the LAN segment use router A as the active
HSRP router. Router B is the standby router for the HSRP. In exhibit 2, the network management
team reported that there is no utilization on the WAN link B. To solve this problem, you decide to
change the logical topology of your LAN, but you are not sure about what changes must be made.
You must manage HSRP or change it to another protocol in order to provide the most scalable
design, automatic redundancy, and load balancing. Which one of these actions would be the best
choice?

Refer to the exhibit.

Which action would make the router the active VRRP router?

A branch router is configured with an egress QoS policy that was designed for a total number of
10 concurrent VOIP calls.
Due to expansion, 15 VOIP calls are now running over the link, but after the 14th call was
established, all calls were affected and the voice quality was dramatically degraded.
Assuming that there is enough bandwidth on the link for all of this traffic, which part of the QoS

configuration should be updated due to the new traffic profile?

Voice quality is bad due to high delay and jitter on a link. Which two actions will improve the quality
of voice calls? (Choose two.)

Refer to the exhibit.

On what will the config class-map VOICE match?

Which two statements are true about bandwidth guarantee? (Choose two)

DRAG DROP
Drag the DSCP value on the left to the correct classes on the right. Not all DSCP values will be used.