Which individual metrics can be used to calculate the composite EIGRP metric?

Which four are possible states in the BGP FSM? (Choose four.)

Refer to the exhibit.

R1 has two eBGP sessions to ISP1 and ISP2 (one to each ISP router), and R1 receives the same
prefixes through both links.
Which configuration should be applied for the link between R1 and ISP2 to be preferred for
incoming traffic (ISP2 to R1)?

Based on the output provided in the exhibit, to which address or location will the router forward a
packet sent to 192.168.32.1?
D 192.168.32.0/26 [90/25789217] via 10.1.1.1
R 192.168.32.0/24 [120/4] via 10.1.1.2
O 192.168.32.0/19 [110/229840] via 10.1.1.3

Refer to the exhibit.

What effect will the as-path filter command that is configured on R4 create BGP routing table?

Refer to the exhibit.

R1 has two eBGP sessions to ISP1 and ISP2 (one to each ISP router), and R1 receives the same
prefixes through both links.
Which configuration should be applied for the link between R1 and ISP2 to be preferred for
incoming traffic (ISP2 to R1)?

DRAG DROP
Drag the statements on the left to the correct OSPF network type on the right.

Two routers configured to run BGP have been connected to a firewall, one on the inside interface
and one on the outside interface. BGP has been configured so the two routers should peer,
including the correct BGP session endpoint addresses and the correct BGP session hop-count
limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall?

You have two EBGP peers connected via two parallel serial lines. What should you do to be able

to load-balance between two EBGP speakers over the parallel serial lines in both directions?

Which of these best identifies the types of prefixes a router running BGP will advertise to an EBGP
peer?