Which vendor-neutral protocol could be used to resolve …
After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco
Discovery Protocol are not visible. Which vendor-neutral protocol could be used to resolve this issue?
What would cause the output to show only the single nei…
A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor
that uses Cisco Discovery Protocol, but it has several routing neighbor relationships. What would cause the output to show only the single neighbor?
What is the result of the implemented command?
Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs. This command is configured globally:
monitor session 2 filter vlan 1 8, 39, 52
What is the result of the implemented command?
What should be done on the Cisco switch to allow for be…
An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the
EtherChannel links is being utilized to reach the web server. What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate
web server?
Why is the EtherChannel bundle not working?
After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the down/down state. Switch A is configured with channel-group 1
mode active, while Switch B is configured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working?
Which three items must be configured to mirror traffic …
Refer to the exhibit.
A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be
configured to mirror traffic to a packet sniffer that is connected to the distribution switch? (Choose three.)
How can the traffic that is mirrored out the GigabitEth…
Refer to the exhibit.
How can the traffic that is mirrored out the GigabitEthernet0/48 port be limited to only traffic that is received or transmitted in VLAN 10 on the GigabitEthernet0/1
port?
Which set of configurations will result in all ports on…
Refer to the exhibit.
Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?
What percentage of bandwidth is reduced when a stack ca…
What percentage of bandwidth is reduced when a stack cable is broken?
Which configuration must be added to the new switch bef…
A network engineer wants to add a new switch to an existing switch stack. Which configuration must be added to the new switch before it can be added to the
switch stack?