Which MST configuration statement is correct?

While logged into a Company switch you issue the following command:
CompanySwitch(config-mst)# instance 10 vlan 11-12
What does this command accomplish?

Refer to the show spanning-tree mst configuration output shown in the exhibit. What should
be changed in the configuration of the switch SW_2 in order for it to participate in the same
MST region?

The network administrator maps VLAN 10 through 20 to MST instance 2. How will this
information be propagated to all appropriate switches?

Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both
have had the command spanning-tree mode rapid-pvst issued on them. What will be the
result?

LAB
Refer to the Exhibit.

The information of the question
You will configure FastEthernet ports 0/12 through 0/24 for users who belong to VLAN 20.
Also, all VLAN and VTP configurations are to be completed in global configuration mode as
VLAN database mode is being deprecated by Cisco. You are required to accomplish the
following tasks:
1. Ensure the switch does not participate in VTP but forwards VTP advertisements received
on trunk ports.
2. Ensure all non-trunking interfaces (Fa0/1 to Fa0/24) transition immediately to the
forwarding state of Spanning-Tree.
3. Ensure all FastEthernet interfaces are in a permanent non-trunking mode.
4. Place FastEthernet interfaces 0/12 through 0/24 in VLAN 20

Refer to the exhibit. The user who is connected to interface FastEthernet 0/1 is on VLAN 10
and cannot access network resources. On the basis of the information in the exhibit, which
command sequence would correct the problem?

You need make configuration changes to an existing layer 3 switch in the Company network.
On a multilayer Catalyst switch, which interface command is used to convert a Layer 3
interface to a Layer 2 interface?

Refer to the exhibit. The switchport output in Figure 1 displays the default settings of
interface
FastEthernet 0/13 on switch SW1. Figure 2 displays the desired interface settings. Which
command sequence would configure interface FastEthernet 0/13 as displayed in Figure 2?

What command could you enter to display the trunking status of a module/port in the switch?
(Type in the answer below):