You are adding an additional LAP to your current wireless network, which uses LWAPP. The
LAP is configured with a static IP address.

Which of the following steps is the first step when the LAP attempts to register with a WLC?
(Select the best answer.

You are configuring a fiber connection between two Cisco Catalyst 3750 switches on which
UDLD is disabled. You connect both the transmit and receive connectors on one end of the
cable to port 1/0/9 on Switch

Which of the following is not information provided from an IP phone to a Catalyst switch
using CDP? (Select the best answer.)

Which of the following are functions that are often provided by an ITSP but are not typically
provided by the PSTN? (Select 2 choices.)

Which of the following should you enable to prevent a switch from forwarding packets with
source addresses that are outside an administratively defined group? (Select the best
answer.)

SIMULATION
Configure the Multilayer Switch so that PCs from VLAN 2 and VLAN 3 can communicate
with the Server.

SIMULATION

Each of these vlans has one host each on its port
SVI on vlan 1 – ip 192.168.1.11 with snm
Switch B –
Ports 3, 4 connected to ports 3 and 4 on Switch A
Port 15 connected to Port on Router.
Tasks to do
1. Use non proprietary mode of aggregation with Switch B being the initiator
— Assumed use LACP with B being in Active mode

2. Use non proprietary trunking and no negotiation
— Assumed use switchport mode trunk and switchport trunk encapsulation dot1q
3. Restrict only to vlans needed
— Assumed either vtp pruning or allowed vlan list. vtp pruning command did not seem to
work on the simulator so landed using allowed vlan list
4. SVI on vlan 1 with some ip and subnet given
5. Configure switch A so that nodes other side of Router C are accessible
— Assumed this to mean that on switch A default gatway has to be configured.
6. Make switch B the root
— Could not get this to work. Exam hung when I tried the command
spanning-tree vlan 1, 21-23 priority 4096

On an Aironet card, LED 0 and LED 1 are blinking alternately. What does this indicate?

Which two statements are true about the configuration of voice VLANs? (Choose two.)

Refer to the exhibit. Which statement is true about the display of the command show pagp 1
neighbor command?