Refer to the exhibit. From the configuration shown, what can you determine about the private
VLAN configuration?

Refer to the exhibit. Consider the following scenario:

Packet A is a TCP packet from host 10.2.2.2., port 65000, going to host 10.1.1.1 on the
SMTP port.

Assuming that this ACL is properly applied on the switch, if this packet is fragmented, which
two of the following statements are true, based on the configuration shown in the exhibit?
(Choose two.)

Refer to the exhibit. Consider the following scenario:

A packet sourced from host 10.2.2.2, port 65001, is going to host 10.1.1.2 on the Telnet port.
Assuming that this ACL is properly applied on the switch, if this packet is fragmented, which
of the following conditions will result, based upon the access list shown in the exhibit?

Which of these is true regarding the configuration and application of port access control
lists?

Refer to the exhibit. Which of these is true based upon the output shown in the command?

Switch# show ip sla application
IP SLAs
Version: 2.2.0 Round Trip Time MIB, Infrastructure Engine-II
Time of last change in whole IP SLAs: 22:17:39.117 UTC Fri Jun
Estimated system max number of entries:15801
Estimated number of configurable operations: 15801
Number of Entries configured: 0
Number of active Entries: 0
Number of pending Entries: 0
Number of inactive Entries:0
Supported Operation Types
Type of Operation to Perform: 802.1agEcho
Type of Operation to Perform: 802.1agJitter
Type of Operation to Perform: dhcp
Type of Operation to Perform: dns
Type of Operation to Perform: echo
Type of Operation to Perform: ftp
Type of Operation to Perform: http
Type of Operation to Perform: jitter
Type of Operation to Perform: pathEcho
Type of Operation to Perform: pathJitter
Type of Operation to Perform: tcpConnect
Type of Operation to Perform: udpEcho
IP SLAs low memory water mark: 21741224
Refer to the exhibit. What best describes the Cisco IOS IP SLA command and output in the
exhibit?

Which statement best describes first-hop redundancy protocol status, given the command
output in the exhibit?
Switch# show ip arp
ProtocolAddressAge(min)Hardware AddrTypeInterface
Internet172.16.233.2290000.0c59.f892ARPAVlan10
Internet172.16.233.2180000.0c63.1300ARPAVlan10
Internet172.16.233.19-0000.0c07.ac0bARPAVlan10

Which statement best describes implementing a Layer 3 EtherChannel?

What benefit results from implementation of Layer 3 switching versus Layer 2 switching in a
fully meshed campus network?

When configuring a routed port on a Cisco multilayer switch, which of these is a required
configuration task that you must perform to enable that port to function as a routed port?