You need to design router redundancy on the Company network. Which three protocols
could be chosen for IP routing redundancy to protect against first-hop router failure?
(Choose three)

You have configured router R1 with HSRP, using the standard defaults. Which three
statements are true of a default HSRP configuration? (Select three)

Router R1 is configured for HSRP. Which of the following are valid HSRP states on R1?
(Choose 3)

Routers can send hello messages in three HSRP states. Which ones are they? (Select
three)

Which command will need to be added to External_A to ensure that it will take over if serial
0/0 on External_B fails?

Refer to the exhibit. The Gateway Load Balancing Protocol has been configured on routers
R1 and R2, and hosts A and B have been configured as shown. Which statement can be
derived from the exhibit?

Refer to the exhibit. HSRP has been configured and Link A is the primary route to router R4.
When Link A fails, router R2 (Link B) becomes the active router. Which router will assume
the active role when Link A becomes operational again?”

What three tasks must a network administrator perform to properly configure Hot Standby
Routing Protocol (HSRP)? (Select three)

You want to allow Router R1 to immediately become the active router if its priority is highest
than the active router fails. What command would you use if you wanted to configure this?

Which command will need to be added to External_A to ensure that it will take over if serial
0/0 on External_B fails?