Given the above OSPF network, which command will RTB use to summarize routes for the
192.168.16.0/22 supernet before injecting them into Area 0?

How is the configuration of a totally stubby area different from that of a stub area?

When the passive-interface command is used on a router, which two routing protocols will
continue to receive routing updates on an interface that is configured as passive? (Choose
two.)

Refer to the exhibit.

Which statement is true?

Refer to the exhibit.

Given the exhibited router output, which command sequence can be added to R1 to
generate a default route into the OSPF domain?
A: default-router
B: ip default-network
C: default-information originate always
D: ip default-gateway

Refer to the exhibit.

There are two eBGP links between AS100 and AS200. Currently the router A to router E link
has an average inbound load of 65% and the router B to router F link has an average
inbound load of 20%. After further investigation, it is found that traffic to the 10.10.1.16/28
subnet is using 45% of the bandwidth on the A to router E link and traffic to the
10.10.1.32/28 subnet is using 20% of the bandwidth on the A to router E link. Traffic to the
10.10.1.48/28 subnet is using 20% of the bandwidth on the B to router F link. If you want to
influence how AS200 sends traffic to AS100, which two commands would you configure in
AS100 to influence AS200 to use the eBGP links more evenly? (Choose two.)

Refer to the exhibit.

AS 65500 is running OSPF as its IGP and has two eBGP connections to the Internet
provider AS 65501. The provider requires that you advertise all of the prefixes in AS 65500
to the provider as a single 192.168.12.0/22 route. Currently only Routers A and B are able to
reach the Internet. Which of the following additions to the configuration will solve this issue?

Which Ipv4-mapped Ipv6 address is equivalent to IPv6 address ::ffff:AC11:AC11?

DRAG DROP
Drag and drop question. Drag each item to its proper location.

DRAG DROP
Place the BGP commands to the proper locations