DRAG DROP
Click and drag the command on the left to the associated task on the right.

By default, which statement is correct regarding the redistribution of routes from other
routing protocols into OSPF?

Refer to the exhibit.

All routers have simultaneously been reloaded, and the DR election has
concluded as expected. Which state is RTC in?

You have been tasked with setting up OSPF on an existing company router usingIPv6.
Which command enables OSPF for IPv6 on a router?

What is the best order for choosing the Router-ID in ospf?

DRAG DROP
Click and drag the associated set of OSPF LEAs on the left to the corresponding area type on the right where this set of LEAs may be seen.

DRAG DROP
Click the resources on the left that you need to create an implementation plan for an OSPF project and drag them to the target zone on the right.

SIMULATION
Route.com is a small IT corporation that is attempting to implement the network shown in the
exhibit. Currently the implementation is partially completed. OSPF has been configured on
routes Chicago and New York. The S0/0 interface on Chicago and the S0/1 interface on
New York are in area 0. The loopback0 on New York is in Area 1. However, they cannot ping
from the serial interface of the satellite router to the loopback interface of the New York
router. You have been asked to complete the implementation to allow this ping.
ROUTE.com’s corporate implementation guideline requires:
The OSPF process ID for all routers must be 24.
The routing protocol for all each interface must be enabled under the routing process.
The routing protocol must be enabled for each interface using the most specific wild card
mask possible.
The serial link between Seattle and Chicago must be in OSPF area 8.
OSPF area 8 must not receive any inter-area or external routers.
Network information
Seattle
S0/0 192.168.34.5/30 – link between Seattle and Chicago
Secret Password: Cisco
Chicago
S0/0 192.168.40.9/30 – link between Chicago and New York
S0/0 192.168.34.6/30 – link between Chicago and New York
Secret Password: Cisco

Refer to the exhibit.

What must be configured on router RTA to summarize all routes from area 0 to area 1?

Refer to the exhibit.

All routers have simultaneously been reloaded and the DR election has concluded as
expected. What state is RTB in?