Which command should you use to verify what networks are being routed by a given OSPF
process?

You have a multi-area OSPF network and you’re concerned because one of the sites is
having connectivity problem to resources in a different area. Which IOS privileged mode

command would you enter to confirm that your network: A. has a path to its ABR, B. has a
path to its ASBR, and C) the SPF calculation is functional?

An OSPF link can be in multiple states at any given moment (ie. Exstart, exchange, full).
Which two IOS commands let you view the state of the link? (Select two)

Which command would display OSPF parameters such as filters, default metric, maximum
paths, and number of areas configured on a router?

Which IOS command would you use to find out which networks are routed by a particular
OSPF process?

The router that is being used for the Internet is low on memory. Because multiple ISP’s are
being used, BGP is needed for Internet routing. Which of the following types of routes should
be received from the Internet providers if the goal is to consume as little memory as
possible?

Which BGP state is a router in when it has found the IP address in the neighbor statement
and has created and sent out a BGP packet but the router has not received a response
back?

You need to enable BGP within your enterprise network. Which two statements are true
regard BGP? (Select two)

You need to determine if you should implement BGP routing within your enterprise.
Implementing this routing protocol in an AS (Autonomous System) is most appropriate
when? (Select 3)

Router PG1 is configured as a route reflector. What would happen if router PG1 would
receive an update from a peer in a different autonomous system?