ABR R1 has been configured with an area 1 stub no-summary command. Which stubby area
type is area 1?

Which of the following answers can be verified as true based on the following command
output from Router R1?
R1#show ip ospf virtual-links
Virtual Link OSPF_VL0 to router 4.4.4.4 is up
Run as demand circuit
DoNotAge LSA alloweD.
Transit area 1, via interface FastEthernet0/1, Cost of using 3

Several links have been broken so that for the next day or two, what was formerly a
contiguous area 0 has been broken into two parts. However, both parts of area 0 have
working links into area 1 using routers with RID 1.1.1.1 and 2.2.2.2. Which answers list the
command on the router with RID 1.1.1.1 to create a virtual link to help solve this temporary
problem?

Router R1 connects to a Frame Relay cloud using a multipoint subinterface, with ten
PVCs associated with the subinterface. What command would make this router not use a
DR and require static OSPF neighbor definition?

Router R1 connects to a Frame Relay cloud using a multipoint subinterface, with ten
PVCs associated with the subinterface. What command would make this router not use a
DR, and dynamically discover OSPF neighbors?

Ten routers, R1 through R10, connect in a partial mesh over Frame Relay. For the mesh, R1
and R2 have PVCs connected to all other routers, but Routers R3 through
R10 act as branch routers, with only two PVCs–one to R1 and one to R2. The routers use IP
subnet 1 0.1.1.0/24, with addresses 10.1.1.1, 10.1.1.2, and so on, through 10.1.1.10,
respectively. The routers all use Inverse ARP to learn Frame Relay mapping information. All
routers use a multipoint subinterface with network type point-tomultipoint nonbroadcast. A
co-worker’s implementation plan lists lots of configuration commands related to this design.
The design states that all hosts should be able to ping all other hosts. Which commands are
required for proper functioning of OSPF in this case? (Choose two.)

Which of the following answers is the least likely reason for an engineer to choose to use
route redistribution?

For a router to successfully redistribute routes between OSPF and EIGRP, which of the
following are true? (Choose two.)

Process EIGRP 1 is redistributing routes from process OSPF 2. Which two of the following
methods may be used to set the metrics of the redistributed routes?
(Choose 2)

Examine the following excerpt from the show ip eigrp topology 10.2.2.0/24 command on
router R1. Which answer can be verified as definitely true based on this output?
External data:
Originating router is 10.1.1.1
AS number of route is 1
External protocol is OSPF, external metric is 64
Administrator tag is 0 (0x00000000)