Refer to the exhibit.

The routing protocols EIGRP and OSPF have been configured as
indicated in the exhibit. Given the partial configuration of router R2, which network will be
present in the routing table of R4?

When policy-based routing (PBR) is being configured, which three criteria can the set
command specify? (Choose three.)

Refer to the exhibit.

Routers R1 and R2 have established a neighbor relationship and are
exchanging routing information. The network design requires that R1 receive routing updates
from R2, but not advertise any routes to R2. Which configuration command sequence will
successfully accomplish this task?

Which three of the following protocols will be forwarded to a host specified by the ip helperaddress interface configuration command if the configuration has not been modified by the ip
forward-protocol udp global configuration command? (Choose three.)

Refer to the exhibit.

Which two statements are true about the partial configuration that is shown? (Choose two.)

A company has a Frame Relay WAN with one central-site router and 100 branch office
routers. A partial mesh of PVCs exists: one PVC between the central site and each of the
100 branch routers. Which of the following could be true about the number of EIGRP
neighborships?

A network design shows that R1 has four different possible paths from itself to the Data
Center subnets. Which one of the following commands is most likely to show you all the
possible next-hop IP addresses for these four possible routes?

Router R1 lists 4 routes for subnet 10.1.1.0/24 in the output of the show ip eigrp
topology all-links command. The variance 200 command is configured, but no other
related commands are configured. Which of the following rules are true regarding
R1’s decision of what routes to add to the IP routing table? Note that RD refers to reported
distance and FD to feasible distancE.

Router R1 has been configured for EIGRP. The configuration also includes an ACL with one
line–access-list 1 permit 10.100.32.0 0.0.15.255–and the EIGRP configuration includes the
distribute-list 1 in command. Which of the following routes could not be displayed in the
output of the show ip eigrp topology command as a result?

seq 5 deny 10.1.2.0/24 ge 25 le 27
seq 15 deny 10.2.0.0/16 ge 30 le 30
seq 20 permit 0.0.0.0/0