DRAG DROP
Drag the appropriate IS-IS routing term to its correct definition.

SIMULATION LAB

1. Seed metric for EIGRP must have the following characteristics:
Bandwidth=512 Kbps
2. Delay=100
3. Reliability=255
4. Load=1
5. MTU=1500
Seed metric for IS-IS must be set to 50.
Only redistribute Level-1 IS-IS routes into EIGRP.
Redistribute EIGPR routes into IS-IS as Level-1 routes.

Refer to the exhibit.

BigBids Incorporated is a worldwide auction provider. The network uses
EIGRP as its routing protocol throughout the corporation. The network administrator does
not understand the convergence of EIGRP. Using the output of the show ip eigrp topology
all-links command, answer the administrator’s questions.
Which three EIGRP routes will be installed for the 172.17.3.128/25 and 172.17.2.0/24 networks? (Choose three)

Refer to the exhibit.

BigBids Incorporated is a worldwide auction provider. The network uses
EIGRP as its routing protocol throughout the corporation. The network administrator does
not understand the convergence of EIGRP. Using the output of the show ip eigrp topology
all-links command, answer the administrator’s questions.

Which three networks is the router at 172.17.10.2 directly connected to? (Choose three)

SIMULATION LAB. (IPv6 OSPF Virtual Link Simulation)
Acme is a small export company that has an existing enterprise network that is running IPv6
OSPFv3. Currently OSPF is configured on all routers. However, R4’s loopback address
(FEC0:4:4) cannot be seen in R1’s IPv6 routing table. You are tasked with identifying the
cause of this fault and implementing the needed corrective actions that uses OSPF features
and does no change the current area assignments. You will know that you have corrected
the fault when R4’s loopback address (FEC0:4:4) can ping from R1 to R4 loopback address.

Special Note: To gain the maximum number of points you must remove all incorrect or
unneeded configuration statements related to this issue.

SIMULATION
LAB (EIGRP Stub Simulation)
By increasing the first distant office, JS manufactures has extended their business. They
configured the remote office router (R3) from which they can reach all Corporate subnets. In
order to raise network stableness and lower the memory usage and broadband utilization to
R3, JS manufactures makes use of route summarization together with the EIGRP Stub
Routing feature. Another network engineer is responsible for the implementing of this
solution. However, in the process of configuring EIGRP stub routing connectivity with the
remote network devices off of R3 has been missing.

Presently JS has configured EIGRP on all routers in the network R2, R3, and R4. Your duty
is to find and solve the connectivity failure problem with the remote office router R3. You
should then configure route summarization only to the distant office router R3 to complete
the task after the problem has been solved.
The success of pings from R4 to the R3 LAN interface proves that the fault has been
corrected and the R3 IP routing table only contains two 10.0.0.0 subnets.

SIMULATION
Company has two links which can take it to the Internet. The company policy demands that
you use web traffic to be forwarded only to Frame Relay link and other traffic can go through
any links that are available. Use BGP attributes to solve the requested action.

Which option is true regarding the synchronization rule?

One of the most important characteristics of OSPF is Multiple areas. Which statement best
describes why this feature is such an important enhancement to earlier routing protocols?

When learning a new route, if a LSA received is not found in the topological database, what
will an internal OSPF router do?