Refer to the exhibit.

R1 accesses the Internet using E0/0. You have been asked to configure
R1 so that a default route is generated to its downstream devices (191.0.0.1 and 192.0.0.1).
Which commands would create this configuration?

Select the best response.

Refer to the exhibit.

How would you confirm on R1 that load balancing is actually occurring
on the default-network (0.0.0.0)? Select the best response.

Refer to the exhibit.

Based upon the configuration, you need to understand why the policy
routing match counts are not increasing. Which would be the first logical step to take? Select
the best response.

Refer to the exhibit.

A partial routing configuration is shown. Complete the configuration so
that only the default-network is redistributed from EIGRP 190 into EIGRP 212. Which ACL
statement completes the configuration correctly?
Select the best response.

Refer to the exhibit.

The partial configuration for an OSPF ASBR and an Area 0 ABR is
shown. Assume the OSPF configurations throughout the network are operable. Which
statement about these configurations is true?

Select the best response.

Refer to the exhibit.

Which three commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP? (Choose three.)
Select 3 response(s).

Refer to the exhibit.

Examine the partial configuration and the routing table excerpt.
Which routes would be redistributed into OSPF area 1?
Select the best response.

Refer to the exhibit.

Examine the partial configuration and the routing table excerpt.
Which routes would be redistributed into OSPF area 1?

Select the best response.

Refer to the exhibit.

A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?

Refer to the exhibit.

Currently the two eBGP links between AS100 and AS200 have an
average inbound load of 65% and 20% respectively. After further investigation, traffic to
10.10.1.16/28 accounts for 45%, and traffic to 10.10.1.32/28 and to 10.10.1.48/28 each
account for 20% of the inbound load. The BGP attributes are currently set at their default
values in both autonomous systems.
If you want to influence how AS200 sends traffic to AS100, which eBGP configurations
would you configure in AS100 to influence AS200 to use the eBGP links more evenly?
(Choose two.)

Select 2 response(s).